Post-cutter edge compactor

There are many solutions required by the motion control of automatic machines, but not all of them make the difference. Our solution of the movement of the axles that compact the edges of the material after the cutters does: it is indeed a reliable solution, implemented with a nema 17 or nema 23 motor, with an added encoder. Thanks to our programmable drives and to torque control we offer, for this type of automation, a high-performance, ready-to-use package which is at the same time low-cost.

Here are the main characteristics:

  • Motors with high torque encoders.
  • Precise and repetitive movements.
  • High energy efficiency.
  • Interfacing with most PLCs or motion boards thanks to the different fieldbuses such as Canopen, Ethercat, Modbus TCP/IP or I/O.



Recommended Products for Post-cutter edge compactor
Vectorial drive "Titanio" Lines for 2-phase stepper motors, programmable and with PLC functionalities

Vectorial drive "Titanio" Lines for 2-phase stepper motors, programmable and with PLC functionalities

Vectorial drive "Titanio" Lines for 2-phase stepper motors, programmable and with PLC functionalities

Vectorial drive "Titanio" Lines for 2-phase stepper motors, programmable and with PLC functionalities

High Efficiency 2 phases hybrid stepper motor with encoder.

High Efficiency 2 phases hybrid stepper motor with encoder.

IDE environment for the programming of the drives of the Titanio Line and SlimLine Line.

IDE environment for the programming of the drives of the Titanio Line and SlimLine Line.